How to Enable .NetFX3 on Windows 10?
Step-I (Open Command Prompt with administrative privileges)
X key and finally hit on
Command Prompt (Admin)
Step-II (Mount your official Windows 10 ISO image or DVD)
Finally Mount your Windows 10 DVD or Windows 10 ISO Images and note the mount point.
Step-III (Run the Dism commands to install the .NetFX3 feature on Windows 10)
Microsoft Windows [Version 10.0.10240] (c) 2015 Microsoft Corporation. All rights reserved. C:\Windows\system32>Dism.exe /online /enable-feature /featurename:NetFX3 /All /Source:J:\sources\sxs /LimitAccess
Note : Here Replace the
J:\with your windows 10 mount point or DVD drive path.
Deployment Image Servicing and Management tool Version: 10.0.10240.16384 Image Version: 10.0.10240.16384 Enabling feature(s) [==========================100.0%==========================] The operation completed successfully.
Step-IV (Check whether the .NET Framework is installed or Not)
My Computer —->
Uninstall or Change Program —-> On left side start the
Turn Windows features on or Off —–> Finally See the
Checked box in front of
.NET Framework 3.5 .
If you see the Check box in front of .NET framework 3.5 then install is succeeded.
Finally you have installed the .Net Framework version 3.5 successfully on your Windows 10 computer. After installing this features now you have successfully run the old windows based apps on your windows 10 PC. For Support and other information use the comment section below.